Step 3
Step 4
Step 2
Step 5
Lower
Extension
Arm
Upper
Extension
Arm
Locknut
Flat
Washer
Flat
Washer
Flat
Washer
Jack
Pivot Bolt
Jack
Pole Bolt
Locknut
Locknut
Flat
Washer
Extension
Arm Bolt
6
Step 3:
Insert jack assembly
through bottom opening in
pole as shown and align jack pivot with hole in pole. Attach jack
to pole using the following: jack pole bolt, two flat washers and a
locknut.
NOTE:
DO NOT
over-tighten. Snug tighten only.
Step 4:
Attach upper mount of jack
to lower extension
arm using the following: jack pivot bolt, two flat washers and a
locknut.
NOTE: DO NOT
over-tighten. Snug tighten only.
Step 5:
Attach upper extension arm pivot holes
with upper holes in pole
following the same hardware and
procedure as in Step 2.
Step 6:
Remove protective material from extension arms.
Extension Arm Attachments
WARNING
Two or three people in good physical condition and capable of
lifting at least 90-100 lbs. (40-45 kg) each are recommended
for safe installation and assembly.
TIME OUT TIP:
The lower extension arm says
“Best in Basketball” and the upper extension
arm says “Goalsetter.com”.
Step 1:
Unpack extension arms.
Position lower extension
arm with jack mount clevis toward pole offset. Align lower
extension arm pivot holes with lower holes in pole.
Step 2:
Attach lower extension arm pivot holes with
lower bushings on pole
using the following: one extension
arm bolt, two flat washers and a locknut. Tighten with
15
/
16
”
wrench and socket so the bushings on the extension arm meet
the bushing on the pole. Do not over-tighten.
HARDWARE:
TOOLS:
Rubber Mallet,
15
/
16
” Socket,
15
/
16
” Wrench
5
/
8
x
7
1
/
2
” Extension Arm Bolt (2)
5
/
8
x
5
1
/
2
” Jack Pole Bolt (1)
5
/
8
”
Locknut (4)
5
/
8
” Flat Washer (8)
5
/
8
x
8” Jack Pivot Bolt (1)
Adjustable Height Goals Only
