16.
17.
Place a level across rim assembly and adjust rim until it is level.
Finish tightening the four nuts.
Figure 10
Figure 11
18.
Attach Rim Cover Plate (#31) using four screws (#32).
See Figure 11.
19.
NEVER USE RIM WITH COVERPLATE REMOVED!
NEVER USE RIM WITH COVERPLATE REMOVED!
Check all nuts and bolts to make sure everything is tightened
properly. DO NOT over tighten pivot points, snug is tight
enough.
23
20
3
5
22
11
22
5
3
20
47
3 5
22
5
3 20
6
22
5
20 3
5
3
47
47
3
5
F
H
E
G
D
C
C
D
47
3
5
B
A
H
G
B
A
E
F
ATTACHING BACKBOARD TO BOARD ARMS
REQUIRES AT LEAST FOUR CAPABLE ADULTS.
14.
With at least three capable people, raise the backboard assembly
up and have the fourth attach Lower Board Arms to lower
mounting holes on backboard using two bolts (#20), two step
bushings (#22), (shipped already installed), four plastic
washers (#5), four flat washers (#3) and two thin
locknuts (#47). See
Figure 10
.
Note: DO NOT over tighten these bolts.
This is a pivot point. Snug is tight enough.
15.
Note: DO NOT over tighten these bolts.
This is a pivot point. Snug is tight enough.
Attach Upper Board Arms to upper mounting
holes on backboard using two bolts (#20), two
step bushings (#22) (if not pre-installed), four
plastic washers (#5), four flat washers (#3) and
two thin locknuts (#47). See
Figure 10
.
Remove protective bag and mount Goal Assembly (#28) and
Rim Pad (#21) to Backboard, as shown in
Figure 11
, using
four bolts (#29), four washers (#26), and four locknuts (#33).
Tighten fasteners, but leave them loose enough to level rim.
Note
: Be sure to
install board arms
to the OUTSIDE of
tube as shown.
Note: Make sure (#21) Rim
Pad is installed between Rim
(#28) and Backboard (#23)
8
Содержание B3300W
Страница 2: ...2...
