INSTALLATION INSTRUCTIONS
NOTE: SOME MODELS MAY REQUIRE NOTCHING THE LOWER BUMPER FASCIA .
STEP 1.
BEGINNIN WITH THE PASSENGER SIDE, LOCATE AND REMOVE THE UPPER BUMPER BOLT. THE BOLT
IS LOCATED BEHIND THE GRILLE ON TOP OF THE BUMPER. THE BOLT IS ACCESSABLE BY REMOVING THE
RIVETS AND PLASTIC TRIM PANEL ON TOP OF THE GRILLE. LOOSENING THE CAMS LOCKS SECURING THE
GRILLE AND REACHING DOWN THROUGH THE OPENING. NOTE: PULL OUTWARD ON BOTTOM OF GRILLE TO
EXPOSE BOLT.
STEP 2.
ATTACH 1038BP UPPER BRACKET TO BUMPER USING THE BUMPER BOLT AND SQUARE SPACER AS
SHOWN. DO NOT TIGHTEN.
STEP 3
. POSITION 1037A CENTER PLATE BRACKET BETWEEN THE GRILLE AND BUMPER AND ATTACH TO TOP
OF 1038BP UPPER BRACKET USING 3/8 x 1" HEX BOLT AND LOCK WASHER. DO NOT TIGHTEN.
STEP 4.
ATTACH 1038CP FRAME BRACKET TO LOWER BUMPER BOLT USING 12MM HEX NUT AND 1/2" FLAT
WASHER AND TO HOLE IN SIDE OF FRAME USING 1/2 x 1 1/2" HEX BOLT, WASHERS AND NUTS AS SHOWN. DO
NOT TIGHTEN.
NOTE: IF EQUIPPED WITH TOW HOOKS REMOVE AND USE THE TOW HOOK BOLT.
STEP 5.
REPEAT THE ABOVE STEPS FOR THE DRIVER SIDE BRACKET.
STEP 6.
ATTACH THE GRILLE AND BRUSH GUARD ASSEMBLY TO THE OUTSIDE OF THE FRAME BRACKETS AND
TO THE CENTER PLATE BRACKETS USING 3/8 x 1" HEX BOLTS, LOCK WASHERS AND NUTS. ALIGN THE GRILLE
AND BRUSH GUARD ASSEMBLY WIT FRONT OF VEHICLE AND TIGHTEN ALL NUTS AND BOLTS.
STEP 7.
REATTACH THE GRILLE AND TRIM PANEL.
