GP-PWM-30-UL
_________________________________________________________________________________
13
© 2018 GoPower!
WARNING:
This unit is not provided with a GFDI device. This
charge controller must be used with an external GFDI device as
required by Article 690 of the National Electric Code for the
installation location.
AVERTISSEMENT :
Cet appareil n’est pas équipé d’un
détecteur de défaut de terre. Ce régulateur de charge doit être
utilisé avec un détecteur de défaut de terre comme l’exige
l’article 690 du Code National Électrique pour l’emplacement de
l’installation.
6.0 Wiring Diagram
The GP-PWM-30-UL Maximum 37.5A rating is based on a 30 amp total
maximum short circuit current rating (Isc) from the solar modules
nameplate ratings. The National Electric Code specifies the PV
equipment/system rating to be 125% of the maximum Isc from the PV
module ratings (1.25 times 30 = 37.5A). E.G. Three modules in parallel
with an Isc of 7 amps each equal a total Isc input of 21 amps. When
selecting PV modules for use with the GP-PWM-30-UL do not exceed a
total nameplate Isc current of 30A. Solar modules list the Isc amps on
their specifications nameplate label.
6.1 Charging Only One Battery
Use the following wiring diagram if you are using the GP-PWM-30-UL to
charge only one battery. Connect your battery to the battery 1 terminals
on the solar controller.
Note: The fuse or
breaker used
should be no larger
than 50 amps
