GP-PWM-10-FM
11
© 2018 Go Power!
5. Torque
all terminal screws per the following:
Stranded Copper 90°C Wire
Wire Size AWG
Rated Torque (in-lbs)
14
20
12
20
10
20
With battery power attached, the controller should power up and display
information. Connect the solar wiring to the controller and remove the
opaque material from the solar array. The negative solar array and
battery wiring must be connected directly to the controller for proper
operation. Do not connect the negative solar array or negative battery
controller wiring to the chassis of the vehicle.
6. Mounting the GP-PWM-10-FM.
Mount the GP-PWM-10-FM to
the wall using the included four mounting screws.
IMPORTANT:
You must set the battery type on the GP-PWM-10-FM
before you begin to use the controller (follow steps in
Section 7
). The
default battery setting is for AGM/LiFePO
4
batteries.
Congratulations, your GP-PWM-10-FM should now be operational. If the
battery power is low and the solar array is producing power, your battery
should begin to charge.
7. Re-torque:
After 30 days of operation, re-torque all terminal
screws to ensure the wires are properly secured to the controller.
WARNING:
This unit is not provided with a GFDI device. This
charge controller must be used with an external GFDI device as
required by Article 690 of the National Electric Code for the
installation location.
