go-e go-eCharger, Руководство пользователя

Страница: 12 / 24

Mounting the Wall Mount
Make sure that the surface is free of distortions, and
if the wall bracket is distorted, the charging box may
no longer be able to be attached. Use the spacers
provided to compensate for any unevenness.
Provide a power supply. If the three-phase
connection is available, insert the wall bracket onto
the charging box and the charging box into the
connection to achieve the best positioning of the wall
bracket. Now mark the top and side edges with a
pencil. You can reach a comfortable height for the
charging box by using the three-phase box approx.
Install 170cm above the floor.
The wall mount is then used as a template to mark
the drill holes. Use a spirit level or a spirit level app to
align the wall mount.
Connecting the go-eCharger
Attention!
Never use the go-eCharger lying on its back; it may
collect water in the Type 2 outlet when it rains.
Connect
After an initial self-test, the LEDs light up in the
number of the pre-set charging current in amps. The
setting knob (5) can be used to select between 6A and
32A. The levels of the selection can be individually
adjusted in the app. It does not matter whether the go-
eCharger is connected in one or three phases.
Page 12
After an initial self-test, the LEDs light up in the
number of the pre-set charging current in amps. The
setting knob (5) can be used to select between 6A and
32A. The levels of the selection can be individually
adjusted in the app. It does not matter whether the go-
eCharger is connected in one or three phases.
Loading Process
Now insert your Type 2 cable into the charger box. All
LEDs light up yellow during the test. The charging
process is started with a clicking sound in the
charging box and indicated by switching the LEDs.
During charging, the LEDs run clockwise around the
charging socket. The number of "tails" corresponds to
the number of phases used to charge while the
rotation speed is dependent on the charging current.
Exit loading process
The loading process is terminated by the vehicle. This
is usually the case when the vehicle's battery is fully
charged. The socket remains locked after completion
of the charging process until the cable is removed
from the vehicle (theft protection).
If you want to interrupt the load prematurely, you can
do this via the function of your vehicle ("cable
unlocking") or via the app ("activation").
ATTENTION:
If the power supply is interrupted, the charging cable
remains locked in the charger box for reasons of theft
protection. To unlock it, it is necessary to put the
c h a r g e r
b o x u n d e r p o w e r a g a i n .
Page 13
!
Attention