BB005x Installation and Configuration Guide
Configuring the BB005x in RFC 2516 PPPoE mode
For configuration of the Gnet BB005x modem/router in this mode, your ISP
needs to provide you with the following information:
•
•
•
►
VPI and VCI numbers for connection across the ATM network. The factory
default values are VPI=0, VCI=35
Your User Name (including the domain name extension if necessary) and
your Password
Authentication type: PAP, CHAP or No Authentication
To configure the Gnet BB005x modem/router in the RFC 2516 mode, please
go through the following steps:
1. Ensure that the RJ-11 Phone Line cable is disconnected from your
modem.
2. Connect the RJ-45 Ethernet cable between the computer and the
modem. Please remove the serial cable if it is connected.
3. Connect the AC Power adapter and turn on the Gnet ADSL
modem/router.
4. Close all programs.
5. Proceed to confirm or change, if necessary, the settings of the network
card on your computer by using the procedures described in the Change
the settings of your computer section: Procedure A for Windows
95/98/ME or Procedure C for Windows 2000/XP. In all cases the
“known IP address” value to be entered is 192.168.7.2
6. Close all programs.
7. Launch your web browser.
8. In the address bar of your web browser type: 192.168.7.1
You will now see the following screen:
9. Click
on
System
.
10. Click on
Clear config
.
11. For the User Name type
admin
(lower case). For the Password type
admin
(lower case).
28
