Doc. No. 0127420 rev. B
Page 9 of 15
Microphone Assembly
Note: Make sure that the microphone is
turned right. The wires must be turned
towards the back mic suspension as
shown on the drawing.
Use service tool (heat zink) when soldering the microphone wires.
Brush EGC-1700 coating to the solder points and let dry for 15 sec
- then brush once more.
Wire, red 12 mm
p/n 15129612
Wire, green 12 mm
p/n 15129812
Wire, amber 12 mm
p/n 115129712
Make sure that the suspensions fit well to the
sound studs/ports on the microphones.
Front mic suspension Back mic suspension
-
IN
+
Make sure that wire insulation is undamaged.
