MINIBRUTE SIDE PANEL INSTALLATION
10/20/2016 – Rev 2.1
www.GMUSynth.com
Page 2 of 3
8)
With the screws removed, carefully pull off the side
panels.
9)
Position your new GMUSynth wood side panels so they are
ready for attachment:
10)
Working on one side at a time, position the side panel
sliding the brackets to the front of the synth as far as
possible, and tightly into the synth body. Try to maintain
pressure on the panel in these directions while inserting the
screws. It’s ok if the bracket holes may look misaligned at
this point. Insert one of the middle self-tapping screws just
enough to engage the threads. Do not tighten.
11)
Continuing to apply pressure towards the side and back of
the synth, thread the remaining self-tapping screws.
12)
Check that the panel is properly aligned by slightly lifting the
synth and inspecting the front panel. Confirm there is little
to no gap between the side and front panel. If a gap exists
loosen screws and adjust so there is no gap.
13)
While maintaining pressure towards the side and front,
tighten all four screws firmly. Take care not to overtighten
and strip the thread channel.
14)
Repeat steps 10-13 to install the other side panel.
15)
With both panels installed, flip the front panel back onto
the keybed.
16)
Holding the keybed to the front panel, carefully flip the
synth back upside down and lay on the towel or foam sheet.
