GMI MEGA DETECTION GOLDSTAR 3D SCANNER, Руководство пользователя, Страница: 24 / 42

GROUND SCAN
Start Point
Scan
How to Use
23
Here the user can specify the starting point of
the scan within the area and there are two
options:
Left: The start of the scan is in the lower left
corner of the scanning area
Right: The start of the scan process is from
the lower right corner of the scanning area
The location of the starting point can be select-
ed using the Left / Right arrow keys, then
pressing the OK key
After completing all the previous settings, the
user will see a screen showing the settings
chosen through the previous steps
You can press the button at the bottom of the
screen “Press OK to Scan” to actually start the
scanning process.
After the setup is complete, make sure that the device is fully and
correctly assembled.
Hold the device in the following manner, and make sure that you
are holding the device fixed to your body without moving, then
stand on the zero or starting point in the scanning area and press
the start button located under the handle of the device.
Keep the M.G.S height steady while scanning, at approximately a
constant distance from the ground.
Make sure to record the scan point at each point by pressing the
start button in manual mode before moving to the next point.
The minimum area of a rectangular scan area must be observed,
as it must be at least 3 x 3 meters in size, and it is preferable that
the dimensions of the scan area be (3 x 3), (6 x 6) or (9 x 9), with
a 30 cm distance between each scan point.