Manual Genius Race
04
5. Advance Timing - Timing 0° and motor type sensored = Zero Boost Modus, indicated by green LED
fl
ashing in neutral
6. Acceleration
7. Start Power
8. Start Current Limit Function
9. Current Limit Function
10. Reverse Function
11. Reverse Delay
12. Max Reverse Amount
13. Neutral Width
14. Speed Mixing Brake
15. ABS Brake Function
16. Auto Brake Amount
17. Minimum Brake Amount
18. Maximum Brake Amount
19. Factory Setting
Every time the throttle stick is moved from the closed position to the full power position and again to the
closed position (closed > full power > closed is one cycle ) the program will change. The Red LED will
fl
ash in accordance with the features as follows
1) Red LED
fl
ashes once ( Motor type setting available )
2) Red LED
fl
ashes twice ( Battery type setting available )
……
18) Red LED
fl
ashes 18 times (Maximum Brake Amount setting available )
19) Red LED
fl
ashes 19 times ( Factory setting available )
At the selected program function to be changed, if the throttle stick is stayed at the full power position
for over 4 seconds, the red and green LED should
fl
ash to indicate that you can now change an existing
parameter to a new parameter. In order to change the existing parameter, move the stick to the minimum
or lower position then again to the full power position.
The inside number of the brackets in the chart is the number of the LED
fl
ashing.
•
The cutoff voltage in automatic mode is as like:
•
- LiPo : 3.2 V per cell = 1S: 3.2 V, 2S: 6.4 V - autodetect number of cells
•
- LiFe : 2S: 4.4 V
•
- NiMh/ NiCd : 4-6 cells, the higher voltage between 3.0 V and 50% voltage when the switch is
•
on.
After you select your wanted parameter, stay the throttle stick at the neutral position for over 4 seconds,
the red LED should
fl
ash and the motor should beep (Mi, Re, Do, Re, Mi sound) to indicate that the
selected parameter is stored at the ESC and other parameters can be selected.
After changing all parameters, if the button is shortly pressed, the ESC is now in standby mode. At this
stage, if you want to change another program parameter, repeat the procedure above, or if all settings
are complicated, turn off the speed controller.
The ESC status when the ESC is powered on through by the setup button.
•
- If the ESC receives correct signals from a receiver, the motor should beep (Do and Re sound),
and if the throttle stick is at the neutral position at this time, the motor should beep ( Do, Re, and
Mi sound ) to indicate the ESC is now in the standby mode.
- If the ESC does not receive any signals from the receiver, the red LED should
fl
ash.
Note: Both stick position setting and programmable parameter setting can be ONLY proceeded
through by the setup button right after the ESC is turned ONLY before a motor turns.
The LED status during operation.
•
Full Throttle
: Red LED on
Neutral
: Green LED on
Full Reverse or Full Brake
: Both LED on
Error
:
Red
LED
fl
ashes
