Note:
when using a brushed DC motor, please ensure that the con
fi
guration between the ESC and the
motor must be in accordance with the selected application in the ESC ( one way-forward or two wayre-
versible). See the detailed con
fi
guration in the
fi
gure.
If soldering would be applied to the ESC over 5 seconds, it could damage the ESC.
4. ESC STICK POSITION SETUP
ESC-Sounds : Do, Re, Mi, Fa, So, La, Ti Do.
1. Turn on the transmitter.
2. Connect the power battery, and switch on the ESC.
3. If all connections are correctly completed, the motor should beep depending on the throttle stick
location.
Do, Re ~~ Do, Re, Mi : If the stick is at the neutral position,
Do, Re ~~
: If the stick is at other position instead of neutral position.
4. If you press and hold the setup button for over 1second, the Green LED should
fl
ash. At this time,
detach your hand from the button, then the Green LED should be ON and the motor should beep (So,
So, La, La, So, So sound) to indicate that the neutral position has been set.
5. Move the throttle stick to the full power position, then the red LED should be ON to indicate that the
full power position has been set.
6. Move back the throttle stick to the full reverse or full brake position, then the red and Green LEDs
should be ON to indicate that the full reverse or full brake position has been set.
7. Move the throttle stick to the neutral position, then the red and Green LEDs should
fl
ash alterna-
tively, and the motor should beep (So, Fa, Mi, Re, Do sound ), then the Green LED should be ON to
indicate that the ESC is now ready to be used.
Note 1:
It is ONLY necessary to make this initial throttle setup again if you are using a different transmit-
ter or the settings have been changed.
Note 2:
After switching on the ESC, the stick position setup COULD be done ONLY before a motor
turns.
Note 3:
If full power position setting can not be done, pls change the Throttle reverse / Normal.
5. USER MODE SETUP
1. Turn on the transmitter.
2. Connect the power battery, and switch on the ESC.
3. If all connections are correctly completed, the motor should beep depending on the throttle stick
location.
Do, Re ~~ Do, Re, Mi : If the stick is at the neutral position,
Do, Re ~~
: If the stick is at other position instead of neutral position.
4. If you press and hold the setup button for over 1 second, the Green LED should
fl
ash for 2 seconds
then the red LED should immediately
fl
ash. At this time, detach your hand from the button, the motor
should beep (Mi, Re, Do, Re, Mi sound), the red LED should
fl
ash once constantly to indicate that the
ESC is now in the
User mode setting
.
Flashing repeatedly once enters
the Motor type setting
. 18 different program features can be set in
this controllers as below.
In the programmable mode, if the setup button is shortly pressed and detached, it comes out of the
programmable mode, the ESC is ready to be used.
1. Select Motor Type
2. Battery Type
3. Cut Off Voltage
4. Power Curve
03
Manual Genius Race
