GLP
German Light Production
(V1.05)
22
1. Strike the lamp (for example in the
LAMP
menu) and wait a while until full
intensity of the lamp.
2. Direct the beam straight on a flat and bright surface/wall (beam open, white, no
gobo, no effects).
Remark:
As the optimum distance of the lamp from lens was adjusted during
the installation or changing the lamp (by turning the screw
A
), it is necessary to
adjust only the second position by turning the screw
B
, in order to center the
so-called
'Hot-Spot'
(the brightest part of the beam).
3. If the Hot-Spot is not in the middle, you can adjust this by turning the screw
B
.
4. If the Hot-Spot is too bright and the beam not even, you can adjust this again
by turning the screw
A
. clockwise (get nearer towards the reflector).
Remark:
A complete even beam can't be reached because of the design of the lamp.
5. Appears the beam more bright at the edge, you can adjust this by turning the
screw
A
counter-clockwise (get nearer towards the lens).
Attention: Never remain the minimum distance between lamp and lens
(1.0mm). Is there any doubt, open the fixture and control the distance!
6
Change a Gobo
The
Y
Y
P
P
O
O
C
C
2
2
5
5
0
0
B
B
a
a
s
s
i
i
c
c
is fitted with standard gobos (outside diameter 27 mm, image
size 23 mm). You can use ether steel or glass gobos.
6.1 Safety
Regulations
•
Pull out the main plug!
•
Wait min. 20 minutes after the last operation to cool down the fixture.
•
Before you put the
Y
Y
P
P
O
O
C
C
2
2
5
5
0
0
B
B
a
a
s
s
i
i
c
c
into operation close the casing, otherwise
your retina can be hurt!
6.2 Realize the Gobo Change
1. Pull out the main plug!
2. Open the upper shell of the head casing by loosening the 4 Phillips screws.
Two on the front side and 2 on the back side of the head.
3. Remove the Gobo carefully by hand.
