DANUBE 2 R500
65
www.glomex.it
ENGLISH
4. No image on the TV (the led
on the control unit is green)
- the receiver is off
- turn off the control unit, turn on
the receiver and then turn on
the control unit again
- the TV set is off or has not
been tuned to AV
- turn on the TV set and tune to
AV channel
- wrong cable connection on the
receiver
- check that the SCART socket
between the TV set and the
receiver is installed correctly
- the channel list is not up-to-
date
- carry out the automatic
channel search in the receiver
menu
- the selected satellite is not the
correct one
- check the selected satellite
5. Intermittent images for short
periods
- the satellite signals are
obstructed by trees, buildings,
overpasses, mountains
- move the boat to allow an
unobstructed view for the
antenna
- the boat is at the boundary of
the coverage area
- bad weather conditions
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
59 in this manual
- wrong SKEW adjustment
- adjust the SKEW by following
the instructions on page 52
- temperature change greater
than 10°C
- turn off and on again the
antenna
- it is necessary to calibrate the
sensors again
- turn off and on again the
antenna
6. The equipment does not find
the satellite (the led on the
control unit is red)
- the satellite signals are
obstructed by trees, buildings,
overpasses, mountains or
attachments installed on the
boat
- move the boat to allow an
unobstructed view for the
antenna or correctly position
the antenna on the boat
- the boat is outside the signal
coverage area
- go back within the coverage
area; refer to the footprints of
the coverage areas on page
59 in this manual
- the boat is moving within the
first 60 seconds after turning
on the equipment
- bad weather conditions
- turn off the equipment for 10
seconds, turn it on again and
make sure that the boat is still
or moves in a straight line
during the first 60 seconds
after being turned on
- wrong SKEW adjustment
- adjust the SKEW by following
the instructions on page 52
- inner failure
- contact the Service Centre
