Globestock G.Winch, Руководство по обслуживанию

Страница: 7 / 15

7
Reassembly
Ensure all damaged / failed components are replaced at
reassembly.
7. REPLACE PAWL
(IF NECESSARY, OTHERWISE
SKIP TO STEP 8)
Using a set of circlip pliers, remove the pawl retaining circlip and
washer. The pawl can then be lifted off the dowel pin. (Keep
covered to prevent the spring-loaded ball bearing from firing off)
To fit the new pawl, push the ball bearing into the cavity of the lever
arm and hold in place whilst positioning onto the dowel. Refit the
washer and circlip.
8. REPAIR ROPE DRUM ALLIGNMENT
(IF
NECESSARY, OTHERWISE SKIP TO STEP 9)
8.1
Remove the 2 case retaining screws and the external nut of
the stay bolt. (Do not adjust any other nuts on the stay bolt as this
will affect the case alignment)
8.2
Lift the case off the body of the G.Winch, exposing the internal
components.
8.3
Using a soft mallet, tap the welded gear down back into
position so that the drum can rotate freely.
8.4
Refit the case, ensuring to align all 3 sleeves back into
position.
8.5
Fasten down the case screws and the stay bolt nut securely.