Globe SP10, Руководство пользователя

Страница: 10 / 20

Page 10
Operating Instructions
Always STOP the mixer BEFORE changing speeds! Failure to do so may damage the
gears or other parts and WILL void the warranty!
6. To change the speed while mixing:
a. press the red stop button, then wait for the agitator to come to a complete stop.
b. change the speed by raising or lowering the speed control lever
c. press the green start button to restart the mixer
NOTE: The SP62P and SP80PL will automatically shut off if the speed is changed while the mixer is in operation.
NOTE: The mixer is equipped with a motor overload protection. If the mixer shuts off during operation, reduce the
batch size and:
a. SP25 and smaller models: Press the stop button then press the overload reset button located
on the back of the mixer.
b. Larger models: Wait two minutes then press the ‘Start” button on the control panel.
NOTE: 2nd speed should never be used on 50% AR or lower with the exception of the SP60. The SP60
requires a 50% reduction in batch size to mix in speed 2 with 50% AR doughs.
NOTE: Reduce batch size by 10% if chilled flour, water below 70°F, ice, or high gluten flour is used.
IMPORTANT:
For heavier loads, the mixer should not run longer than fifteen minutes without
pausing for a cool down period of at least fifteen minutes or more before resuming mixing.
For lighter loads, the mixer should not run longer than thirty minutes without pausing for a
cool down period of at least thirty minutes or more before resuming mixing.
7. When the ingredients have been thoroughly mixed, press the red stop button to stop the mixer.
NOTE: If the timer was used, the mixer will automatically stop when the time has expired.
8. Lower the bowl by pulling the bowl lift lever forward and down to its resting position. For models SP40 and
SP60, rotate the bowl lift wheel counterclockwise until it stops. For models SP62P and SP80PL, press the
down arrow (blue button) until the bowl stops.
9. Rotate the bowl guard to the left so it is in the open position.
10. Remove the agitator from the planetary shaft by lifting it upwards, then rotating it counterclockwise until it is
unlocked. Lower the agitator and remove from planetary shaft.
11. Push each bowl clamp backwards to unlock the bowl from the bowl cradle.
12. Lift up slightly on the bowl so it clears the pins on the bowl cradle.
Most batches are heavy. Always use two people to remove and transport the loaded
bowl after mixing is complete. A bowl truck is included with the SP60, SP62P and
SP80PL models and should be used to unload bowls containing more than 50 lbs.
per batch.