NOTE: Check the surrounding location of where you would like to place the light and ensure that it is clear of
debris or dust. In order to activate the motion sensor the light needs to be placed in a dark area.
OPTION 1: Mounting with 3M magnetic
strip (included)
• Remove the plastic covering on one side
of tape
• Place tape in the rectangular recessed
area on the base of the light
• Remove the plastic covering on the stick
side of the tape
• Place the light in the desired location.
Press firmly for 5 seconds so that the
tape adheres to surface
NOTE: Be cautious of what surface the double
sided tape is attached to, as it may remove paint
or damage surfaces.
OPTION 2: Mounting with screws
(included)
• Measure two holes 7.87 inches (20cm) a
part in the desired mounting area
• Screw in the screws based on your
measurements to the desired mounting
area
• Once the screws are in place, align the
two holes on the back of light with the
two screws
• Slide the light to the left to secure it in
place
LIGHT POSITIONING
• Place the light in a dark space to activate the motion sensor
• The light will not function if it is placed in a well-lit area
• The motion detection range has a angel of 120 degrees
• Motion can be detected up to 10-12 ft away
INSTALLATION INSTRUCTIONS
1m
2m
3m
4m
