![background image](http://html1.mh-extra.com/html/global/flogos-lite/flogos-lite_instruction-manual_2231996025.webp)
Flogos-lite™ Instruction Manual
Flogos-lite
™
8.
Remove the Windscreen from the lower case top where the skirt was stored. Begin installing
the Windscreen by inserting the upright supports which have black caps into the Windscreen
support sockets. There is an opening at the rear of the Windscreen which should be oriented to
the rear of the Flogos Lite in order to gain access to the controls. At the inside of each of the four
corners
2
of the Windscreen you will find a sewn “pocket”. While draping the Windscreen over
the Flogos Lite place each rod into one of these pockets. Pull the bottom edge of the Windscreen
down and press the hook and loop fastener onto the loops on the top edge of the Skirt. The flap
covering the controls can be “unzipped”, raised upward, and secured by the small tabs of hook
and loop fasteners located above the flap. Access to the controls is then possible. During opera-
tion of the Flogos Lite this flap should be lowered and secured by the hook and loop fastener
along its’ lower edge.
9.
Fill the Flogos Lite with the correct amount of de-ionized water
3
so that the water level is 1.5
- 2 inches (3.8 – 5 cm) above the top of the bubbler heads. Add the correct amount of Flogos
Juice Concentrate
4
.
10.
Place the tank cover onto the tank which is required for proper priming.
11.
With power switch OFF adjust air and helium valves as required
5
.
1
Left and right on the Flogos Lite is determined when facing the controls from the operating position. This is also
referred to as the “rear”.
2
24” model has a total of 4 Windscreen support “pockets”, 36” model has a total of 8
3
9 gallons- 24” model, 25 gallons- 36” model
4
42 ounces (1.24L) 24” model, 1 US gallon (3.78L)- 36” model
5
Helium setting-2, Air setting- 10 for optimum operation. Other settings will be used for special operations and
effects or for maximum efficiency.
Instruction Checklist
22