Flogos-lite
™
Flogos-lite™ Instruction Manual
Instruction Checklist
While it is possible for one person to set up and operate the Flogos Lite it has been found to be
much easier if two persons set it up.
Set-up
1.
Position the Flogos Lite in the desired place for the event. Although the Flogos Lite will still
need to be manually leveled, it is to your advantage to begin with a place as level as possible.
2.
Unlatch the 4 latches which secure the top of the case. Remove the top and set aside noticing
that the Skirt and Windscreen are secured to the lower side of the case top.
3.
Remove the tank cover and set aside. Each of the two persons should be standing on the
sides of the Flogos Lite where the oval shaped hand holds are located on the Inner Top. Each
person grasps the inner top by placing their hand through the oval shaped hole. Lift the Inner
Top keeping it relatively level as it is lifted. Each person then unfolds one of the legs by depress-
ing the leg locking button located in the gap near the hinge point of the leg. The leg is folded
downward until it locks into position with an audible “click”. Each person then holds the Inner
Top with the opposite hand and repeats the leg unfolding with the remaining leg making sure
there is an audible “click” indicating the leg is locked into position.
4.
Lower the Inner Top until the legs rest on the Leg Locks located in each of the four corners
of the lower case. Guide each leg into the square hole in its Leg Lock. There are no locking
mechanisms to hold the legs into the Leg Locks. Each leg, though, must rest in the bottom of its’
respective Leg Lock in order for the Inner Top to be properly leveled and for proper operation of
the Flogos Lite.
5.
Attach the helium hose to the fitting on the gas control solenoid located on the lower side
of the Controller Enclosure. Using two 9/16” open end wrenches (included) hold the fitting on
the solenoid valve with one and tighten the gas hose fitting with the other. This prevents undue
stress being placed on the solenoid valve which could damage it. Insert the female end of the
power cord into the receptacle in the end of the lower right side of the Controller Enclosure.
Attach the female quick coupling of the air hose to the male air fitting on the air filter/regulator.
6.
Use the bulls-eye level on the control panel or a carpenter’s level to adjust the Flogos Lite as
level as is possible in both horizontal directions.
7.
Remove the Skirt from the lower side of the case top. The Skirt is attached by pressing the
hook and loop fastener attached to the skirt to the hooks which are attached around the outer
perimeter of the Inner Top beginning on the left hand side of the rear of the Inner Top
1
. Con-
tinue attaching the skirt around the Inner Top tucking the lower edge of the skirt into the lower
case as you proceed. The small gap left at the junction of the ends of the skirt is where the hoses
and power cord pass through.
(continued on next page)
21
