Instruction Manual
5
Outdoor Drinking Fountain w/ Bottle Filler
INSTALLATION
• It is recommended that 2 or more people install this unit.
• This fountain must be mounted on a solid, flat surface with adequate strength (concrete
pad recommended) capable of supporting 400 lbs.
• Locate and install plumbing through ground as required. Refer to Rough-In Guide (page 4)
for proper location and correct plumbing.
• Install a drainable shut-off valve (not included) if in a freezable environment.
• Installation of a trap on the water drain line may be necessary; check local plumbing codes.
WARNING:
The fountain is rated for inlet water pressure of 20-105 PSI. A pressure reducing
regulator should be used if the inlet water supply exceeds 105 PSI. Any damage caused by
reason of connecting this product to supply line pressure higher than 105 PSI will void warranty.
Flat-head anti-theft screw
M6 x 10 (qty 24)
1. REMOVE ACCESS PANELS
REMOVE
To gain access to the drain and water line connections, remove all access panels detailed below
using the provided torx key wrench (H1) or torx drill bit (H2) to remove all (24) M6 x 10
flat-head anti-theft screws on back side of the bottle filler and pedestal, as well as the underside
of the drinking fountain pan:
REMOVE
REMOVE
REMOVE
