Page 83
KINO-LX Motherboard
Figure 4-3: Jumper Locations
4.6.1 Clear CMOS Jumper
Jumper Label:
JP4
Jumper Type:
3-pin header
Jumper Settings:
See
Table 4-3
Jumper Location:
See
Figure 4-3
If the PCB
fails to boot due to improper BI
OS settings, use this connector to clear the
CMOS data and reset the system BIOS inform
ation. To do this, use the jumper cap to
close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1 and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
Содержание 2801330
