Chapter 6 — Service and Repair
Aliens Extermination System Manual
Page 26 of 56
040-0120-01 Rev. B 10/10/2006
Figure 19.
Gun Button, Lamp, and Micro Switch
Gun Coil Assembly Service
The coil assembly provides the force-feedback recoil when the gun is fired. Perform the
following steps to replace components of the coil assembly:
1.
Open the gun case as described on page 24.
2.
Remove the two screws shown below from the right side of the gun.
3.
Remove the nut that secures the ground wire to the ground lug on the side of the coil assembly
mounting plate, as shown below.
4.
Remove the two screws that secure the coil assembly mounting plate to the gun shaft, as shown
below.
Figure 20.
Gun Coil Assembly Service
5.
Reverse these steps to re-install the coin assembly. Be sure to secure the ground wire to the
ground lug on the coil assembly mounting plate.
Содержание Aliens Extermination
Страница 55: ......
