9
Chapter 3 Adapter Installation and Configuration – Windows
®
98
3-1 S
YSTEM
R
EQUIREMENTS
In order to install and use the GL-241102 PCMCIA card your PC system must meet the following
requirements:
A PCMCIA Type II or Type III slot
PCMCIA revision 2.10 compliant card and socket services
Windows
®
98 (with the Windows
®
CD, for use during installation)
500 Kbytes free disk space for utility and driver installation
3-2 I
NSERTING THE
A
DAPTER
To insert the GL-241102 Network Adapter into a notebook computer, do the following:
1. Locate an available Type II or Type III PCMCIA slot.
2. With the PCMCIA adapter’s 68-pin connector facing the PCMCIA slot and the “GL-
241102PCMCIA” label facing up slide the PCMCIA adapter completely into the PCMCIA
slot.
Fig. 5 Insert the GL-241102 into Notebook
After properly inserting the Network Adapter into your notebook, continue with the GL-241102 driver
and PRISM Configuration Utility installation.
NOTE:
The PCMCIA slot allows “hot swap” of PCMCIA adapter. You may insert or remove the
GL-241102 / PCMCIA adapter from the slot anytime, even when the power of your computer is
on.
NOTE
: Windows
®
98 requires that the Network card and socket services must be compliant with
the PCMCIA revision 2.10 specification. Please check the documentation of the PCMCIA driver
before installing the GL-241102 PCMCIA adapter.
NOTE: To comply with FCC RF exposure requirements, this device should be operated in
lap-top computer configurations with a separation distance of 20 cm or more between the
antenna and persons. The antenna should not be operated next to a person’s body.