4.0
SITE SELECTION
The first and most important consideration when choosing a prospective antenna site is whether or not the area
can provide an acceptable “look angle” at the satellites. A site with a clear, unobstructed view is preferred. Also
consider obstruction that may occur in the future such as the growth of trees. Your antenna site must be selected
in advance so that you will be able to receive the strongest signal available. To avoid obstructions, etc., conduct an
on-site survey with a portable antenna. The satellite antenna can be installed on a ground pole, wall/roof mount, or
non-penetrating roof mount with 2.88” or 3.50” outside diameter mast. The chosen mount type should be assem-
bled and in place before installing the antenna. Refer to instructions packed with mount for its proper installation.
The mast pipe must be vertical and plumb to insure ease of alignment.
As with any other type of construction, a local building permit may be required before installing an antenna. It is the
property owner’s responsibility to obtain any and all permits.
Before any digging is done, information regarding the possibility of underground telephone lines, power lines, storm
drains, etc., in the excavation area should be obtained from the appropriate agency.
Because soils vary widely in composition and load capacity, consult a local professional engineer to determine the
appropriate foundation design and installation procedure. A suggested foundation design with conditions noted is
included in this manual for reference purposes only.
4.1
WARNINGS
LAW:
Installation and installer must meet local codes and ordinances regarding safety! Installation of this product
should be performed only by a professional installer and is not recommended for consumer Do-It-Yourself installa-
tions.
DANGER:
WATCH FOR WIRES!
Installation of this product near power lines is extremely dangerous and must
never be attempted. Installation of this product near power lines can result in death or serious injury! For your own
safety, you must follow these important safety rules. Failure to follow these rules could result in death or serious
injury
1.
Perform as many functions as possible on the ground
2.
Watch out for overhead power lines. Check the distance to the power lines before starting installation. Stay at
least 6 meters (20 feet) away from all power lines.
3.
Do not install antenna or mast assembly on a windy day.
4.
If you start to drop antenna or mast assembly, move away from it and let it fall.
5.
If any part of the antenna or mast assembly comes in contact with a power line, call your local power company.
DO NOT TRY TO REMOVE IT YOURSELF!
They will remove it safely.
6.
Make sure that the mast assembly is properly grounded.
WARNING:
Assembling dish antennas on windy days is extremely dangerous and must never be attempted. Due
to the surface area of the reflector, even slight winds create strong forces. For example, this antenna facing a wind
of 32 km/h (20 mph) can undergo forces of 269 N (60 lb).
BE PREPARED TO SAFELY HANDLE THESE FORCES
AT UNEXPECTED MOMENTS. ATTEMPTING TO ASSEMBLE, MOVE OR MOUNT A DISH ON WINDY DAYS
COULD RESULT IN DEATH OR SERIOUS INJURY.
Global Skyware is not responsible or liable for damage or injury
resulting from antenna installations.
WARNING:
Antennas improperly installed or installed to an inadequate structure are very susceptible to wind
damage. This damage can be very serious or even life threatening. The owner and installer assumes full responsibil-
ity that the installation is structurally sound to support all loads (weight, wind and ice) and properly sealed against
leaks. Skyware Global will not accept liiability for any damage caused by a satellite system due to the many un-
known variable applications.
14
