Global Manufacturing Viber Mini Backpack, Руководство по эксплуатации

Страница: 4 / 12

1. Inspect the vibrator system for damage. Never use a damaged vibrator.
2. Have all components of the vibrator system received proper maintenance?
VMG Gasoline Motors: Clean air filter every 25 hours and change engine
oil after every 50 hours of operation. Refer to the Robin Owner’s Manual for a
complete maintenance schedule.
Flexible Shafts: Re-grease core after every 50 hours of use or if core rattles excessively.
Vibrator Head: Monitor bearings. Viber® heads require no lubrication.
3. Are all vibrator system connections tight? Apply Teflon® tape to the casing threads,
before attaching the head, to give a watertight connection.
4. Do you have the proper fuel? Use unleaded gasoline with a pump octane rating of 86
or higher.
5. Check oil level in engine.
II. Assembling Your Internal Concrete Vibrator
& Quick Disconnect
The VMG-1750BP Gasoline Power Unit comes fully assembled except for the throt-
tle control. Mount the throttle control, using the two screws provided, to the holes
located on the lower left side of the frame (when facing the backpack frame from
the rear, engine side). Orient the control so the black knob points outward, FAST is
at the top, and STOP is at the bottom.
All Viber® system components are interchangeable. All flexible drives (cores and
casings) can be used to attach any head to any power unit. For optimum perfor-
mance and wear consult your
Smart Parts™ SYSTEM GUIDE or the table in SECTION
VI for the best combination of components.
1. Attach the flexible drive (casing with lubricated core installed) to the power
unit. The VMG-1750BP comes with a quick disconnect for attaching flexible
drives to the power unit. To attach a quick disconnect drive fitting to the flex
drive, first apply a layer of Teflon® tape to the casing threads, add fitting and
turn it clockwise to tighten. Use a small pipe wrench or channel locks to be
sure the connection is tight. (If you do not have an assembled flex drive, the
core must be lubricated before installing it in the casing. Run the core
through a handful of Viber® Core Grease as it is inserted into the core.
Attach the end of the casing, where the core was inserted, to the quick
disconnect drive fitting.)
2.
CAUTION
CHECK YOUR EQUIPMENT
WARNING
Always be sure the gasoline power unit’s ignition switch is in the “off”
position before assembling or disassembling your system.
WARNING
NEVER attempt to change flexible drives while the engine is running