FCC NOTICE
This device complies with Part 15 of the FCC Regulations. Operation is subject to the
following conditions:
●
This device may not cause harmful interference.
●
This device must accept any interference received, including interference that may cause
undesired operation.
IMPORTANT:
Changes or modifications to this unit could void your right to operate this
unit. Your COMMUNICATOR is set up to transmit a regulated signal on an assigned
frequency. It is against the law to alter or adjust the settings inside the COMMUNICATOR
to exceed those limitations. Any adjustment to your COMMUNICATOR must be made by
qualified technicians.
SAFETY INFORMATION
●
Never open your COMMUNICATOR’s case.
●
Never change or replace anything in your COMMUNICATOR except the battery.
Your COMMUNICATOR may interfere with TVs or radios, even when operating properly.
To determine whether your COMMUNICATOR is causing interference, simply turn it off. If
the interference ends, your COMMUNICATOR is causing it. Try to eliminate interference
by moving your COMMUNICATOR away from the receiver. If you cannot eliminate
interference completely, the FCC requires that you terminate COMMUNICATOR use.
Electromagnetic Interference/Compatibility:
Nearly every electronic device is susceptible
to electromagnetic interference (EMI) if inadequately shielded, designed, or otherwise
configured for electromagnetic compatibility.
●
Turn your unit OFF in any facilities where posted notices instruct you to do so. Hospitals
or health care facilities may be using equipment that is sensitive to external RF energy.
●
Turn your unit OFF when on board an aircraft when instructed to do so. Any use of the unit
must be in accordance with airline regulations or crew instructions.
Hazardous Environments:
Do not operate the COMMUNICATOR in hazardous
environments, explosion or fire may result. Do not operate the COMMUNICATOR near
unshielded electrical blasting caps. Under certain conditions, COMMUNICATORS can
interfere with blasting operations and may cause an explosion. Turn your
COMMUNICATOR to the OFF position to prevent accidental transmission when in a
blasting area or in areas posted: "Turn off two-way radios." Construction crews often use
remote control RF devices to set off explosives.
3
