G100 User Manual
G100 User Manual
Page 19 of 31
●
User name/ account
: If the H.323 protocol used with a calling card, please
enter the account information on the calling card into this field..
If “Type of account” is set to “md5 account”, enter the ID in “User name/ account”.
If “Type of account” is set to “account”, enter the H.323 ID here.
If “Use dialplan” in the telephone settings (on next page) is set to “prefix”, enter
country code and card number, followed by a # character here. Your service
provider can tell you the correct settings.
If the SIP protocol is used, please enter your username into this field.
For the MGCP protocol, please enter local endpoint id (eg., aaln/0) here.
For Net2phone, please enter account of Net2phone card here.
●
pin:
H.323 protocol: please enter password of your calling card into this field; for
md5 accounts, enter password of your account here. If “Use dialplan” in the
telephone settings (on next page) is set to “prefix”, enter password, followed by a
# character here. Your service provider can tell you the correct settings.
For the SIP protocol, please enter the password of your account in this field.
For the MGCP protocol, please enter domain name here.
For Net2phone, please enter password of Net2phone card here.
Note
When MGCP protocol is used, some servers require adding “[ ]” outside
the domain name.
●
Phone number:
The local phone number or username of this phone. The
phone number is part of the account information from your service provider.
●
RTP Type of service
: Enter data packet priority for IP packat headers here.
Values range between 0 and 255 with 255 indicating highest priority. This
parameter must be supported by the network in order to have effect.
●
Register port:
The local UDP port registered with server to accept incoming
handshaking messages. The default port number for MGCP protocol is 2427. The
default port number for SIP protocol is 5060. For H.323 or Net2phone, any
number between 1024 and 65535 is acceptable.
●
Signal port:
For the H.323 protocol, signal port is Q.931 port using TCP
protocol, can be any number between 1024 and 65535.
●
Control port:
For the H.323 protocol, this port is H.245 port using TCP protocol,
can be any number between 1024 and 65535.
