Troubleshooting guide
General note: Check all connections between transmitter and receiver units with
the source and TV are correct and not damaged. Please refer to the set up
configuration instructions if unsure
.
I do not see a picture on the remote TV
•
Check that the TV is switched on
•
Check the TV is set to display from the HDMI port.
•
Check that the Receiver Green and Blue LED are on (not flashing).
No LED: check the power supply is connected and switched on at
the wall plug.
Blue LED is flashing fast: Receiver is not connected.
•
Check Transmitter
•
Check the coax connection from transmitter to
receiver.
Blue LED is flashing slowly: Connected but waiting for Source
input
•
Check Source is switched on
•
Check HDMI cable between Source and TX input
connector.
•
Restart the Receiver (power cycle)
•
Check the HDMI cable between the Receiver unit and TV is connected and
not damaged.
Replace HDMI cable
•
Check the picture quality through the coaxial RF output port directly to the
TV RF input
The picture quality on the remote TV is poor
•
Check the coax connection from transmitter to receiver.
•
Reposition the Receiver unit: Signal strength maybe too low or on the
edge of range.
•
Check the picture quality on the main TV (Transmitter Loop through). If
this is poor then the quality of the input signal is inadequate.
Page 6
