Assembly Instructions
SAFETY GATE
2
Mounting the gate to a wall:
1. Hold the gate against the wall in the desired location
and mark the location of the mounting holes.
2.
Predrill the holes to connect the gate if needed
(based on material).
Adjusting the gate length:
1. Twist the plastic collars counter-clockwise to loosen.
2. Pull on the end of the gate until the desired length
is achieved.
3. Twist the plastic collars clockwise to tighten.
3. Mount the gate to the wall using appropriate hardware
for the wall material (hardware not included).
4. Disconnect the clapper plate (2) from the gate and
remount on the opposing wall using appropriate
hardware for the wall material.
WARNING
Clapper plate must be installed for
this gate to satisfy OSHA 1910.23
2
