4
f
Cordless Wet/Dry Vacuum
OPERATION INSTRUCTIONS
1. To turn vacuum on or off, use the on/off switch located
at the front of the vacuum cover. When turning vacuum
on, make sure it is properly plugged in first while it is
still off. Turn switch off before unplugging after finishing
vacuuming, or when changing accesories.
2. To connect hose to vacuum, insert end of hose into inlet
and rotate clockwise until locked. To remove, rotate
counterclockwise and then pull.
3. To use the blower, turn the on/off switch off. Insert end
of hose into air outlet, located in the left of the vacuum
cover, then turn clockwise to tighten. Turn the switch on.
WEAR EYE PROTECTION AND A DUST MASK WHEN USING
THE BLOWER.
4. To connect wet/dry nozzle to hose, insert end of hose
into brush outlet and rotate clockwise until tight. To
remove, rotate counterclockwise and then pull.
5. Clean the vacuum tank after every use. To access the
vacuum tank, remove the vacuum cover by opening the
two side clamps and pulling the cover up and out of the
tank. If contents of the tank are wet, clean and dry the
tank after discarding contents.
6. Clean the HEPA filter after every use. To access the filter,
remove the vacuum cover. Turn the filter locking knobs
counterclockwise and remove the filter. Clean the filter
under cold, running water. Do not use detergents or
soaps to clean the filter.
WARNING
DO NOT use vacuum to suck
or blow burning or flammable
material or otherwise hazardous
chemicals
1
2
4
5
6
6
3
