© by GLOBAL GARDEN PRODUCTS
72FL hydro
2.5
.
1
OPENING THE WHEEL COVER
1 / 1
쑮
쑮
쑱
쑱
WORKSHOP MANUAL
pag.
MODEL YEAR 2016
3/2015
2.5 OPENING THE WHEEL COVER
The engine and the mechanical units can be rea ched
by turning back the wheel cover (1).
There are specific indications for opening the cover
which are shown below and also in the instruction
handbook.
Remove the grass-catcher or stoneguard and move
the machine to a flat floor. Raise the cutting deck to
its maximum height and place blocks (2) of about 65
– 70 mm beneath its edge in order to support the deck
during subsequent operations.
Put the drive re le ase lever in the «ENGAGED» posi-
tion. This is be cause the parking brake needs to be
disengaged to ensure the necessary movement to the
speed lever.
Unscrew the knob on the lever (3) and put it into po-
sition «R».
Open the access hatch (4) and unscrew the nut (5)
with a 13 mm spanner.
Release the lever (6) so that the deck rests on the
blocks, and keep it held to the side so that it does not
slip into any of the notches. Grip the base of the seat
(7) and turn back the cover.
When closing, make sure that the channel (8) is pro -
perly fitted onto the support (9) and resting on the
right-hand guide. Put the lever (3) into position «R»
and lower the cover (1) at the level of the levers (3)
and (6).
First put the lever (6) into its housing, and then lever
(3), lower the cover until it centres on the fixing screw.
If this has been done correctly and the guide (9) is
pro per ly positioned, the opening of the channel will
ea sily slip into the hole in the plate (10) without any
need to guide it in manually.
If it does not enter easily and correctly,
Adjust the insertion [see 4.10].
Fully tighten the nut (5), put the lever (6) in position
«7» engaging it in the stop notch,and remove the
blocks (2). Then refit the lever knob (3) and the hatch
(4).
8
8
9
10
7
10
8
6
1
3
2
5
4
<= ...BACK... <=
