ADDRESSABLE VERSION WITH IO UNIT
A
B
C
D
E
F
- Battery Terminal Connections
Connect batteries as shown on page 6 of this manual. Maximum battery capacity for boxed units is 2 x 12V 7Ah batteries.
- Supply Output Terminal Connections
This output supplies a nominal voltage value of 28V DC. Current drive capacity depends on module specification.
- Supply Input Terminal Connections
- Loop Connections
Analogue Loop Connections. Device is not polarity conscious.
- Output relay Terminal Connections
A single pole changeover relay is provided. Activation of relay is possible via panel programming using IO group feature.
Please refer to panel installation manual for further details.
- Fault Relay Terminal Connections
A single pole changeover relay is provided. Activation of relay is caused by any fault detected within the monitoring
circuitry of the module. When device is in fault condition, the analogue value reported to the panel is 2 and it is indicated
by the panel as a supply fault. In these cases both the GENERAL and SUPPLY FAULTS LEDs are ON. Location of the fault is
also provided on the LCD screen where both the Loop and ADDRESS of the device generating the fault are indicated on
the LCD screen.
K1
F1
Battery Fuse
L2
L1
SPLY IN
CN2
ADDRESS
1
2
3
4
5
6
7
8
BA
T
K2
BAT FLT
CHAR FLT
OUT
- +
- +
- +
24V IN
A
B
C
D
NC C NO
F
AUL
T RELA
Y
OUTPUT RELA
Y
NC C NO
E
F
1
2
3
Manufacturers of Fire Detection Equipment
INSTALLATION MANUAL V.3 - 07/2016
GFE-BCM
