SERVICE AND MAINTENANCE OF YOUR DRYER
GENERAL OPERATION
This dryer is activated by an infrared sensor. The dryer operates as long as hands are below
nozzle. There is a maximum 80 second running time with a safety over-ride feature, if hands
are not removed. Each component used in your dryer has been designed to provide years of
trouble-free service. However, if trouble should develop, it can normally be located by visual
examination. Removal or replacement of most parts, is simple and can be done without
special tools.
IF THE DRYER WON’T TURN ON:
Check electrical service, circuit breaker. Make sure proper voltage is being supplied to the
dryer. Check for loose or disconnected terminal to sensor. INCREASE sensitivity (
F
Igure
3
)
by using a flat-blade screwdriver and CAREFULLY turning the adjustment pot located on the
sensor CLOCKWISE
1/3 Turn MAx
. Turn . If necessary, replace sensor.
IF DRYER WILL NOT SHUT OFF:
Make certain black foam is attached to lens and lens is clean. If damaged, replace.
DECREASE sensitivity (
F
Igure
3
) by CAREFULLY turning the adjustment pot located on
the sensor. Use a small flat-blade screwdriver.
1/3 Turn MAx
. COUNTER-CLOCKWISE. If
necessary, replace sensor.
IF COLD AIR IS COMING FROM THE NOZZLE:
Turn off breaker for 30 seconds to reset thermostat. If required. remove the cover and vent,
check the heating element. If the element is broken or burned out, replace it.
IF NO AIR IS COMING FROM THE NOZZLE AND HEATING ELEMENT GLOWS:
Remove the cover and check to see that the fan revolves freely. Check and replace motor,
if required.
FOR ANY OTHER PROBLEM, CONTACT FACTORY FOR ASSISTANCE.
CLEANING -
DO NOT spray cleaning solvents thru dryer vents. DO NOT use abrasive,
chlorinated, or highly alkaline cleaners. DO NOT use oil based cleaners.
SEMI-ANNUALLY remove the cover and clean all lint and dust from the mechanism, inside
of cover, and plastic window.
Clean cover with a mild soap or detergent and warm water, using a soft cloth or sponge.
PARTS LIST FOR YOUR DRYER (Figure 2)
ITEM PART NO. DESCRIPTION
1
GX202
COVER, WHITE ABS (MUST SPECIFY DRYER MODEL #)
2
GX202-M
COVER, WHITE STEEL (MUST SPECIFY DRYER MODEL#)
3
GX202-C
COVER, CHROME PLATED STEEL (SPECIFY DRYER MODEL #)
4
GX212
VENT ASS’Y W/ LENS AND FOAM GASKET
5
GX216
MOTOR, 110-120V INCLUDES BLOWER WHEEL (GX1)
6
GX217
MOTOR, 208-240V INCLUDES BLOWER WHEEL (GX3)
7
GX218
HEATING ELEMENT 110-120V (GX1)
8
GX220
HEATING ELEMENT 208-240V (GX3)
9
GX228
BLOWER WHEEL
10
GX239
SENSOR COMPLETE, 110-240 VOLT
11
GB232
TAMPER-PROOF SCREWS & SECURITY WRENCH
F
igure
3
S
eNSitivity
a
djuStMeNt
+
-
F
igure
2 - E
xploded
v
iew
DISCONNECT POWER BEFORE INSTALLING
DESUNA LA ELECTRICIDAD ANTES DE HACER REPARACIONES
WARNING:
