19
Make sure the QUICK RELEASE PLATE
is in alignment and square with the bottom
of your Camera, and make sure the
“Threaded Insert” on the base of your
Camera is aligned with one of the
“Mounting Holes” in the QUICK
RELEASE PLATE.
NOTE
:
You have a Video Camcorder or Film
Camera that is larger than the one used in this
Manual, then you might wish to first find the true
front to back center of gravity of your camera by
rolling the base of your Camera on a pen until it is
balanced upon the pen, the mark this point on your
Camera’s side with a small piece of tape or a grease
pencil, and then use this marking to center the
QUICK RELEASE PLATE over your Camera’s
center of gravity.
Now use a CAMERA MOUNTING
SCREW and a ¼” WASHER to attach the
QUICK RELEASE PLATE to your
Camera.
NOTE:
If
the
Shorter
CAMERA
MOUNTING SCREW does not work then
try
the
slightly
larger
CAMERA
MOUNTING SCREW. Also try using more
than one ¼” WASHER or no ¼”
WASHERS at all if you trouble with the
mounting procedure.
***You can use the same MOUNTING SCREWS
and WASHERS for the HD-1000 and HD-4000.
With your Camera base side up in your lap
and with the QUICK RELEASE PLATE in
place, use a flat head screwdriver to secure
the QUICK RELEASE PLATE to your
Camera using the CAMERA MOUNTING
SCREW and ¼” WASHER combo you
have just selected.
NOTE: Do not over tighten this Screw.
Over
tightening
could
break
the
“Threaded Insert” on your Camera
Base.
32
33
34
