SECTION 5. OPERATING YOUR CHAIR
Adjustable Height Backrest
The backrest upholstery is incrementally adjustable in height. To adjust do the
following:
Note: All upholstery is secured by the use of Velcro Tabs
1. Undo seat to backrest connecting flap by pulling up on Velcro flap at bottom
of back upholstery.
2. Undo backrest upholstery by pulling up on both sides of folded over section
of back upholstery and pull centre upholstery panel away from back frame
3. Undo clothing protectors on either side of back upholstery by pulling out on
Velcro tabs
4. Lift centre tensioning straps off either back bar.
5. Undo screws in back bars and move tube to nearest hole to suit desired
height. Ensure that tubes on either side are at the same height.
6. Replace screw and tighten firmly.
7. Refitting of upholstery is the reverse of procedures 1 to 4
Adjustable Tension Back Upholstery
Your chair is fitted with back upholstery that can be tensioned to suit your individual
needs. To adjust do the following:
1. From behind the chair lift upholstery panel away from Velcro to access
tensioning straps
2. Each strap can then be adjusted to suit your requirements by either loosening o
tightening each strap.
3. Once the desired tension has been achieved fold back upholstery down onto
Velcro fasteners
Adjustable Angle Backrest
Your chair has 4 increments of seat to back angle. To adjust do the following:
1. Remove Quick release wheels.
2. Undo clothing protectors on either side of back upholstery by pulling out on
Velcro tabs
3. Undo and remove Top screw in side hinge plates. Ensure that oval shaped
insert does not fall out.
4. Move backrest bar, forward or back, to next position.
Note: The oval shaped
insert in the side hinge plate provides adjustment for 2 increments.
Reversing this insert provides the next 2 increments. The increments
are: 90 and 80 degrees, 85 and 75 degrees.
5. Replace screw and tighten firmly
6. Replace clothing protectors by reversing point 2.
