Glentek SMA8105, Руководство по эксплуатации и обслуживанию

Страница: 30 / 66

30 Glentek Inc., 208 Standard Street, El Segundo, California 90245, U.S.A. (310) 322-3026
CHAPTER 5: CONFIGURATION
5.4.1 +15V/+5V Logic Level Configuration (Default, S2-1=OFF):
•
+15V: S2-1 - OFF.
•
+5V: S2-1 - ON.
5.4.2 Standard Configuration for Sine/Resolver Velocity Mode and
Current Mode:
5.3.7 Simulated Tach - Reverse Configuration (S2-2: Default=OFF):
The simulated tachometer reverse switch is turned ON to reverse the spinning
direction of the motor or prevent the motor from running away in case of incorrect polarity
of the feedback signal.
5.3.8 Simulated Tach - Speed Configuration (S2-1, Default=ON):
The simulated tach speed switch should be ON unless the user cannot reach the
maximum rpm required per the following formula: Low Speed Applications(S2-1:ON) -
MAX. RPM at 25500/number of motor poles, High Speed Applications(S2-1:OFF) -
MAX. RPM at 51000/number of motor poles .
5.4 Sine/Resolver Mode Amplifier Configuration:
The following table shows the dip switches that need to be configured for the Type A, B,
C, and D configurations. The standard configuration is shown in bold.
Dip-switch Name Velocity Mode Current Mode
S1-1 ENCODE / 2 See section 5.4.3
S1-2 ENCODE * 125 / 128 See section 5.4.3
S1-3 (NOT USED) OFF OFF
S1-4 MTR REVERSE See section 5.3.5 (normally OFF)
S1-5 TACH REVERSE See section 5.3.7 (normally ON)
S1-6 INTEGRATOR See section 5.3.3 (normally OFF)
S1-7 VEL MODE ON OFF
S1-8 CUR MODE OFF ON
Type A Type B Type C Type D
LIMIT
)
S2-8 - OFF
S2-5 - ON
S2-8 - ON
S2-5 - OFF
S2-8 - OFF
S2-5 - OFF S2-8 - ON
S2-5 - ON
INHIBIT S2-7 - OFF
S2-4 - ON
S2-7 - ON
S2-4 - OFF
S2-7 - OFF
S2-4 - OFF S2-7 - ON
S2-4 - ON
RESET IN
S2-6 - OFF
S2-3 - ON
S2-6 - ON
S2-3 - OFF
S2-6 - OFF
S2-3 - OFF S2-6 - ON
S2-3 - ON
MTR TEMP S2-2 - ON not available S2-2 - OFF not available
FAULT standard not available not available not available