Glenmac Harley T6, Руководство оператора

Страница: 28 / 40

26 PN-P970612 (06/2005)
Figure 5
ASSEMBLY
--IMPORTANT NOTICE--
Do NOT add front PTO half to Power Box Rake ®
yet. Follow instructions and important notice
concerning the front PTO in the Attaching and
Detaching Power Box Rake
®
section.
5. Attach the barrier mount to tube beneath the gearbox
using 1/2" U-bolt and top lock nuts. Attach barrier bar
to ears on barrier mount.
6. Attach the two gauge wheel assemblies to the main
frame with two 1/2" U-bolts and nuts.
7. Mount the left and right end plates to the frame.
8. Check the gear lube level in the chain case. Add
#00 fluid gear grease, if required.
9. See Clutch "Run-In" under maintenance on Page
22. Follow all directions and safety procedures.
This should complete the assembly of your new Power
Box Rake
® . Make sure that all guards/shields are in
place and are not removed during use.
WARNING
•
Make sure all hydraulic hoses, fittings, and
valves are in good condition and not leaking
before starting power unit or using equipment.
Check and route hoses carefully to prevent
damage. Hoses must not be twisted, bent
sharply, kinked, frayed, pinched, or come into
contact with any moving parts. Operate
moveable components through full operational
range to check clearances. Replace any
damaged hoses immediately.