IDENTIFYING YOUR OIL FILLED RADIATOR GL 7015
USING YOUR OIL FILLED RADIATOR
Remove the heater and all the accessories from the carton. The Oil filled heater is packed with the castor wheels unattached. Attach
the wheels before operating as explained below:
Assembly
• Place the heater body upside-down on a scratch-fee location,make sure it is stable and will not fall.
• Screw off the wing nuts from the u-shaped bolt provided. Attach the u-shaped bolt to the flange between first and second fins
(near the front cover).
• To attach the castor mounting plate to the heater body, insert the threaded ends of the u bolt in the holes on the castor mounting
plate.
• Screw the wing nuts back to the u bolt and fasten the wing nut properly. Do not over tighten, this may damage the radiator flange.
• The rear flange must be mounted between the end two fins.
Caution:
Do not operate without wheels attached. Operate the Oil Filled radiator only in up right position, (wheels on the bottom, controls on the
top), any other position could create a hazardous situation.
Power setting switch
Oil filled fins
Turbo
Cord storage
Castors
Thermostat control
Handle
