8
To install your device 15 cm (6 in.) from the floor (height recommended by
CONVECTAIR), follow the instructions below:
1- Release the back panel by pinching and pulling the insertable tabs on the back
of the device (Figure C).
2- Place the center of the back panel’s lower marking holes (No. 2 Figure C)
at measurement C (see tables, Figures C - D - E - F - G) from the floor, and draw
a mark.
3- Check that the back panel is horizontal, mark the 2 upper mounting holes,
then drill the 4 holes.
4- Reposition the back panel onto the wall and secure with 4 screws
and plugs if necessary (not supplied).
Tab
Figure C
Example of back panel:
7733 500 W
2
C
