30
This device is equipped with an automatic thermal safety feature. During abnormal
operation (for example, blocked air inlet or outlet), the device automatically stops.
Once the abnormal operation is corrected, and as soon as the device has cool sufficiently,
it will automatically restart.
NOTE:
If the problem persists, contact your installer.
To keep the device clean, CONVECTAIR recommends performing regular maintenance. To
remove dust, use a soft cloth. To remove a stain, dampen the cloth.
For enhanced performance and maximum efficiency of the device, it is recommended to
remove dust regularly (once every two weeks) by vacuuming the air inlets and outlets.
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS, WHICH COULD DAMAGE
THE COATING OF THE DEVICE.
ALL WORK PERFORMED ON OUR DEVICES MUST BE DONE WITH THE POWER
OFF AND BY QUALIFIED AND CERTIFIED PERSONNEL. FAILURE TO DO SO MAY
INVALIDATE YOUR WARRANTY.
RECOMMENDATIONS AND ADVICE
Your
CONVECTAIR
heater becomes hot during use. Particular care must be taken in order to educate young
children.
Do not insert objects into the openings of the grilles; this could cause short circuits, fires or damage to
devices.
Any other use not recommended by
CONVECTAIR
may cause short circuits, fires or injury to users.
In some conditions, the grille of the devices may turn yellow after some time. This phenomenon is not due to
a manufacturing defect. Rather, it is caused by the ambient air which contains fumes or suspended particles,
which are heated and then exhausted through the grille. This phenomenon is particularly visible on «pure
white» devices and can cause severe discolouration.
Prevention: it is advisable to clean the grills frequently, especially for appliances installed in places
exposed to cigarette smoke or in the kitchen. CONVECTAIR devices must never be used during
construction work or other activities which generate a lot of dust.
When switching on the
CONVECTAIR
for the first time, a slight smoke may emerge from it. This phenomenon
is quite normal and will go away on its own after 2 or 3 minutes of operation of the device.
Automatic Thermal Safety
Maintenance
