Glem GTH750TC, Инструкция пользователя

Страница: 14 / 48

14
INSTALLATION INSTRUCTIONS
These instructions are for a specialized
installer and are a guide for the installation
process, regulations and maintenance
in accordance with the law and current
standards. If the built-in oven or any other
appliances that produce heat, need to be
installed directly underneath the cooking
hobs in ceramic glass, IT IS NECESSARY
THAT THE APPLIANCE (oven) AND THE
COOKING HOBS IN CERAMIC GLASS
ARE ADEQUATELY ISOLATED . Failure
to follow this precaution, could cause a
malfunction in the TOUCH CONTROL
system.
POSITIONING
The domestic appliance was built in order to
be encased on a work surface, the way it is
illustrated in the graph (Fig.1). Predispose
sealing material along the whole perimeter
Fig. 4 (the dimensions of the cut Fig.1).
This operation is necessary to avoid any
liquids penetrating the work top, as it is
not possible to guarantee that the top, the
glass and their connection are completely
flat. Lock the domestic appliance into
place with 4 supporters, keeping in mind
the width of the surface (Fig.2). If the lower
part of the appliance after installation, is
accessible via the lower part of the furniture,
it is necessary to mount a separating panel
keeping in mind the distances indicated
(Fig.3) if the appliance is being installed
underneath an oven, this is not necessary.
The appliance is not inteded to be operated
by means of an external timer or separate
remote-control system.
ELECTRICAL CONNECTIONS
(Fig.5)
Before making the electrical connections,
check that:
- the system ratings meet the ratings
indicated on the identification plate fixed
on the lower part of the worktop;
- the system is fitted with efficient ground
wires in accordance with the laws and
current standards.
Grounding is mandatory by law.
If the domestic appliance is not supplied
with a cable and/or suitable plug, use
material suitable for the absorption value
indicated on the identification plate and the
operating temperature.
If wishing to make a direct connection to
the mains, an omnipolar switch must be
installed with a minimum 3 mm opening
between the contacts and appropriate
for the load indicated on the plate and in
accordance with current standards (the
yellow/green ground conductor must not
be disconnected by a switch).
When the appliance has been installed, the
omnipolar switch must be easily reachable.
CLEANING AND MAINTENANCE
Remove any residues of food and drops
of grease from the cooking surface by
using the special scraper supplied on
request (Fig.7). Clean the heated area
as thoroughly as possible using suitable
products, and a cloth/paper, then rinse with
water and dry with a clean cloth. Using
the special scraper (optional) immediately
remove any fragments of aluminium and
plastic material that have unintentionally
melted on the heated cooking area, or
residues of sugar or food with a high sugar
content.This way, any damage to the
hob surface can be prevented. Under no
circumstances should abrasive sponges,
or corrosive chemical detergents, such as
oven sprays or stain removers, be used.
WARNING: STEAM CLEANERS
MUST NOT BE USED.
USE
Use the touch control system in the
corresponding position according to
individual cooking needs. Keep in mind
that the higher the number, the more heat