Glem GHI9100BK, Инструкция по эксплуатации

Страница: 66 / 71

66
and power button will beam. Press low button again and the motor will stop.
Indicator light of low button and power button will be off. The above steps can be operated
repeatedly.
4.4 After the hood works at high speed for 7mins continuously, the motor will automatically
switch to middle speed.
4.5 Low speed, mid speed and high speed cannot work at the same time. When hood is on high
speed, press low speed button, it will turn to low speed at once; when it is in low speed, press
middle speed button, it will turn to middle speed immediately, and so on.
CARBON FILTER REPLACMENT
Activated carbon filter can be used to trap odors. Normally the activated carbon filter should
be changed every 3 to 6 months according to your cooking habits. The disassembly procedure
of activated carbon filter is as below:
(3) Remove the al filter.
(4) According to the arrow, rotating the activated carbon lock plates on both sides to the
parallel position of the carbon filter and then remove the activated carbon
.
-Apply reverse procedure to install the charcoal filter
NOTE:

Make sure the filter is securely locked. Otherwise, it would loosen and cause danger.
 When activated carbon filter attached, the suction power will be lowered.
REPLACING THE BULB :

Remove the grease filter.

Use a tool or the hand to press the spring splinter of both sides of LED light to the inside,
until the light is pressed out, see pic 1.Then slightly pull the light connecting wire out, and
dismantle the terminal of the light connecting wire. See pic 2.

Apply the reverse procedure to reinstall the light.
• ILCOS D code for this lamp is: DSR-1.5/65-S-64
– LED modules –round lamp
– Max wattage: 2x1.5 W