Gleamous GL5, Инструкция по эксплуатации

Страница: 11 / 14

Operation Instructions:
1.
Switch on the power, The buzzer is with long sound and the power indicator “G” lightens, the system
enters in standby mode.
2.
Switch on the water heater by press “ ”. The display screen will display the setting temperaure & real
outlet water termperature.
3.
The user can set the desired temperature by touch the control button “+”, “-”. Press the “+” or “—”button
each time,the temperature will increase or decrease 1
℃
.
4.
The user can also set temperature by slide the touch aera. Slide touch slowly from left to right or from
right to left each time, the temperature will increase or decrease 5
℃.
5.
Press button“…”can shift display mode among water flow & the setting temperature of outlet water.
6.
In some case, when the incoming water temperature is too low, if water is not heat enough for shower
even though you already set on max power, you can reduce the water inflow by adjusting the regulator
valve to get your desired temperature.
7.
If the product you get is with a shower set, you can choose several selections of spray types by turning
the shower head.
Notice:
A.
When you are showering, do not spray water to the water heater.
B.
When you taking shower, if close the water valve and open again in very short time, the water
temperature will probably be higher than your previous setting temperature because of excess heat,
please be careful to avoid scalding.
C.
Power off: After use, press “ ” to switch off the water heater FIRST, then turn off the water inlet
valve.
D.
If this heater will not be used for a long period of time, disconnect the main power( air-break switch
or RCCB). Shall the unit is to be left unused for an extended period of time in a cold region, drain off
the water inside it to avoid freezing.
Water Temperature Regulation
The product highest outlet water temperature can up to 5
o
0 C
。
When you are showering, the outlet water
temperature should be not higher than 45
℃
.
10