Gleamous DSL-30N, Инструкция по эксплуатации

Страница: 4 / 8

3
开/关
出水温度
状态显示
开 关
3
开/关
LED Display type control panel
1
2
6
4
5
1.On/Off
2.Temperature setting
3.Power setting
4.Setting temperature
5.Water flow indicator
6.Outlet water temperature
LED display type
LED
Cold water inlet
Hot water outlet
F i g .2
The Installation shall comply with AS/NZS 3500.4
1)Switch on the unit, the buzzer sounds once the unit is in standby mode.
2)Press the ON/ OFF button, the screen will light and the unit starts heating; press the button once
again to stop heating.
3)Press Temperature Setting button to set heating temperature from 35
℃
to 95
℃
Press the button
each time, the temperature will increase in 5
℃
. When in setting state, the LED screen will flash
the temperature setting for 3 seconds. After setting the temperature, it will show the temperature
of the water in the tank.
4)Press “Power Setting” button to choose the heating power for the heater. The user can choose
different heating power according to requirement.
5)Malfunction code of water heater:
“
E1” means electric current leakage has occurred.
“
E2” means the temperature sensor of outlet water is open/ and has short circuited.
6)When the water in the tank has reached its set temperature, the unit will stop heating and it will
go into warm mode.
7)The unit has memory function. Press “ON/OFF” button when using next time, the unit will
revert to last working temperature.