Rigel Electronic Dartboard
Item 42-1032
GLD Products
1-800-225-7593
www.gldproducts.com
6
Mounting Using the Keyhole Slots
1.
Choose a location that has at least 10 feet of open ! oor space in front of the board. Use a wall
stud for mounting whenever possible.
2.
Determine the location for the dartboard. Place a mark on the wall 68 inches (172.7 cm) from the
! oor. This mark is the " nal position of the center of the dartboard (bullseye).
3.
Locate studs and use wood screws or sheet metal screws to secure the dartboard if the mark is on
the stud. The head of the screw must be larger than 3/16" and smaller than 5/16".
4.
If the mark is not over a stud, use the mounting hardware that is appropriate for your type of wall.
5.
Measure 75-5/8" (192 cm) up from the ! oor and place a mark on the wall. Then measure sideways
5-1/2" (13.9 cm) and place a mark on the wall. Use a level to check that all marks are horizontal.
6.
Drill pilot holes at the two marks. These are for the mounting screws.
7.
If using wall anchors, follow the instructions under Wall Anchors on page 5.
8.
Insert screws into anchors until a 3/8" (9.5 mm) gap is left between the wall and the screw head.
9.
Hold the dartboard so the two screw heads " t into the lower part of the keyholes. The dartboard
should slide down 1/2 inch and the screw heads will hold it on the wall.
10. Screws can be tightened or loosened to provide a secure mounting.
Center of Bullseye
Wall
Throwing or
Toe LIne
Plumb Line from
Face of Board to Floor
Floor
96 in.
68 in.
Содержание RIGEL
Страница 42: ...This page left intentionally blank ...