GLD Products
727 Dartboard
Item 42-1010
1-800-225-7593
6
www.gldproducts.com
Mounting Using the Keyhole Slots
1. Choose a location that has at least 10 feet of open floor space in front of the board.
Locate and use a wall stud for mounting whenever possible.
2. Determine the location for the dartboard. Place a mark on the wall 68 inches (172.7 cm)
from the floor. This mark is the final position of the center of the dartboard (bullseye).
3. Locate studs and use wood screws or sheet metal screws to secure the dartboard if the
mark is on the stud. The head of the screw must be larger than 5/16" and smaller than
3/8".
4. If the mark is not over a stud, use the mounting hardware that came with your dartboard.
5. Measure 7" (17.7 cm) directly up from the bullseye mark and place a mark on the wall.
Use a level to check that the 2 marks are vertical.
6. Use the top mark and measure out level 2 3/4" (6.9 cm) to the left and right. Place a mark
on the wall.
7. Drill pilot holes at the two marks. These are for the mounting screws.
8. If using wall anchors, follow the instructions under
Wall Anchors
on page 5.
9. Insert screws into anchors until a 1/4" (6.5 mm) gap is left between the wall and the
screw head.
10. Hold the dartboard so the two screw heads fit into the lower part of the keyholes. The
dartboard should slide down 1/2-inch and the screw heads will hold it on the wall.
11. Screws can be tightened or loosened to provide a secure mounting.
Center of Bullseye
Wall
Throwing or
Toe Line
Plumb Line from
Face of Board to Floor
Floor
96 in.
68 in.
Содержание 727
Страница 28: ...This page left blank intentionally ...