700-OM-UK-001 v1.0
–
09 Jul 2020
Need assistance? +44 (0)1379 658300 [email protected]
Page 10 of 17
Re-Initialisation
If the manual override has been used the product may require re-initialising. With the manual override handle back in the horizontal
position, check that the door is re-engaged with the drive mechanisms. To do this run the mechanisms completely closed by pushing
the close button on the control switch, next push the open button on the control switch and run the mechanisms to approximately
halfway open and stop them (the mechanisms are concealed by brush strip which can be pushed aside to check the positions of the
mechanisms). Lastly, gently push the door manually until it engages with both mechanisms (you should hear a sound). Once mains
power has been restored it may be necessary to re-initialise the product by pressing close on the control switch. The product is then
ready to resume normal service.
If further assistance is required, contact Glazing Vision to arrange for an engineer to visit and resolve the issue.
