Glaziar Predator D12, Инструкция по эксплуатации

Страница: 39 / 63

www.glaziar.com / info@glaziar.com
39
TROUBLE SHOOTING
Check the following before contacting technical support.
PROBLEM POSSIBLE CAUSE SOLUTION
The device does not work
The power is not connected Insert the plug into the wall outlet
The water tank is full Empty the tank
The tank has not
been replaced correctly
Replace the tank
Water removal capacity is too low
Runtime is too short Be patient and wait
Ambient temperature or humidity is
too low
It is normal that the device does not
dehumidify in these conditions
The device works, but reduces the
relative humidity insuffi ciently
The room is too big
We recommend using a dehumidifi er
with a greater capacity
There is too much ventilation
Reduce ventilation(e.g. close
windows and shut doors)
The air fi lter is clogged
Clean the air fi lter
Set humidity is higher than the
ambient humidity
Set the humidity lower than ambient
humidity
Dehumidifi er is blowing out warm air
The dried air is passed over heating
coils before it is blown into the room as
part of the dehumidifying process
This is normal, a dehumidifi er is not
an air cooler
The display is not showing the
humidity set point
The display shows the room relative
humidity not the set point
Press the humidity control button
once to see the target relative
humidity
Water on fl oor
There is residual water in tank, and the
device is lurched too much by moving
Be careful when move the tank
The dehumidifi er is noisy
The air fi lter is blocked or the device
is on an uneven surface
Clean the fi lter or put the device on a
fl at surface