6
Installing a Surface Mounted Vertical Tier System Mirrored Cabinet
A.
Determine the desired height and use a level to
mark a horizontal line. Be sure to allow a minimum
clearance of 1” above and below any light fixture, ob-
struction and plumbing fixtures. Remember the base of
the cabinet box is 3/4” smaller than the face and the
door.
B.
After the bottom wall mount bracket is properly fas-
tened to the wall, unpack the
V
TS Wall Bracket,
V
TS-
Spacer, Plastic Wall Anchors and Screws from the
package.The
V
TS Spacer & Brackets will give you the
exact height for the top cabinet.
C.
Determine the desired hinge side of the cabinet;
place the bottom cabinet into the bottom wall mount
bracket (see step 1). Place the
V
TS Wall Bracket on
the top flange of the bottom cabinet as illustrated (see
step 2). Mark and drill (2) 7/32” holes in the
V
TS Wall
Bracket. It is recommended that you try and locate a
wall stud to fasten the #10 x 1 1/2” Phillips head wall
anchor screws. Drill (2) matching holes into the wall
with a 3/16” masonry bit. Insert the #10 PWA Plastic
wall anchors into the wall holes and tap flush with the
w all.
D.
Place the
V
TS Wall bracket into position and fasten
to the wall.
E.
Clean the top section of the bottom medicine cabi-
net, free of any dust or debris.
F. The
V
TS Spacer is prepped with double sided
mounting tape and one strip of Decorative Chrome
Plated finish trim for the exposed spacing. Remove the
tape cover and carefully place the
V
TS Spacer on the
top of the bottom cabinet. The
V
TS Spacer is designed
to snugly fit up against the frontedge. (See figure 2). The
two-sided tape is very strong; make sure you position
the
V
TS Spacer correctly before you apply adhesion
pressure. The
V
TS Spacer will be very difficult to remove
if installed incorrectly.
G.
It is now time to place the top cabinet into position.
Make sure the hinges are on the same side as the bot-
tom cabinet. Slide (2) Top Surface Mount Brackets (425-
00) into the top-mounting groove. It is recommended to
dry fit the cabinet into position before removing the tape-
from the
V
TS Spacer. Mark the top holes for the top sur-
face mount brackets, drill and install (2) plastic wall
anchors #10 PWA. You may have to adjust the
V
TS Wall
Bracket Screw to fit the top cabinet into position.
H.
Remove the tape from the
V
TS Spacer; carefully
place the top cabinet into position. Fasten the Top Sur-
face Mount Wall Brackets with (2) wall anchor screws
(Step 3). Make sure the
V
TS Spacer is flush with both
cabinets. Peel off the protective tape from the
V
TS finish
trim.
1
2
3
Содержание R-VTS-16-54H
Страница 5: ...5...
