P. 2
P. 3
Filling the Sack Dispenser:
1.
To load the dispenser pull the arm
back (Fig. E) and place sacks
centrally over the rounded end.
2.
Allow the arm to swing back into
place, ensuring that the sacks stay
looped over it (Fig. F).
NOTE: If using Glasdon sacks tear the
central hole out of the pack and ensure
that this side of the pack faces out to
allow users access to the sacks (see Fig.F).
INSTALLATION:
Ground Fixing:
If using Glasdon fixings please follow
the instructions supplied with the
fixing kit.
Kits containing 4 bolts should be
placed in the holes shown in Fig G.
Kits containing 3 bolts should be
placed in the holes shown in Fig H.
If using non Glasdon fixings ensure
that 50mm diameter washers are used
on the base of the unit.
We strongly recommend that the bin
is always installed into a concrete slab
unless soft earth installation method is
being used. Tarmac or block paved
areas are not suitable fixing surfaces.
Fig. G
Fig. H
Post Fixing:
1.
Using a ‘C’ Bracket (ITEM 1) as a
guide, mark 4 holes to be drilled in
the back of the bin, as shown in Fig. I.
2.
Drill the 4 marked holes right through
with an 11mm drill bit.
3.
Insert a Sleeve (ITEM 2), a Washer
(ITEM 3) and a Screw (ITEM 4) into
each hole.
4.
Tighten the screws in to the C Brackets
with the 5mm Allen Key (Fig. J).
Banding can now be passed through the C
Brackets to attach the Bin on to an existing
post (Fig K).
If using Tespa or Tamtorque banding from
Glasdon please follow the Instructions supplied
with the Kit. If non Glasdon Banding is used
follow the manufacturers instructions.
Fig. E
Fig. F
Kit Contents:
Tools Required:
ITEM 1
‘C’ Bracket
x 2
Pen/Scribe
ITEM 2
Steel Sleeve
x 4
Hand Drill
ITEM 3
M8 x 20mm Washer x 4
11mm Drill Bit
ITEM 4
M8 Screw
x 4
5mm Allen Key
Fig. I
Fig. J
ITEM 1
ITEM 1
ITEM 2
ITEM 3
ITEM 3
Fig. K